Quote:
Originally Posted by gg3
That would have been too easy.
Which throttle positions is it boggey at,or is it across the whole range?
So when at full operating temp. how does it run-
Idle-
1/4-
1/2-
3/4 to full-
|
The problem is im not really sure how its supposed to be running as its my first 2 stroke. Every time I get a improvement, I think wow this is way better. not knowing that it was bad before. However even i could tell it was shocking on the n1ef needle.
So my best geuss is this
Idle- it idles ok-ish in neutral but it sometimes will stall on low speed single track and the air screw seems to have little effect on idle.
1/4 - i think it could be a lot cleaner here it will load up a bit unless i open the throttle more
1/2- Its ok but still a bit sluggish on it
3/4 to full- It seems ok here it pulls ok, but it did improve when i went from clip 2 to clip 1 on the n3eg needle
Over all it is easy to tell it could be a LOT cleaner. Whatever jetting i use it always seems to be too rich overall.
so far i have only just got it to pull a power wheelie in 3rd gear. It will do one easily in 2nd though. with 13/50 gearing