View Single Post
  #10  
Old 04-08-2017, 11:40 PM
Zman's Avatar
Zman Zman is offline
Platinum Level Site Supporter
 
Join Date: Apr 2010
Location: Burbs of Chicago
Posts: 1,818
Default

Thank you Sir!

So I could actually run the 12mm under the 14mm to make it a bit thicker and allow for more room for the compression stack to move.

For my situation is there a benefit to leaving the bleed stack in place or should I invert it as shown below?

Am I correct that the 24mm in the middle of the twelve 32mm will soften the initial part of the stroke when compared to the consecutive stack of 32mm?

Nut
Cup Washer 4 holes
​Spring
big silver washer with collar
​​Piston
​32mm (x6) 0.11mm
24mm (x1) 0.11mm
32mm (x6) 0.11mm
30mm (x1) 0.11mm
28mm (x1) 0.11mm
26mm (x1) 0.11mm
24mm (x1) 0.11mm
22mm (x1) 0.11mm
20mm (x1) 0.11mm
18mm (x1) 0.11mm
16mm (x1) 0.11mm
14mm (x1) 0.11mm
12mm (x1) 0.11mm
11mm (x2) 0.25mm
20mm (x2) 1.58mm
Reply With Quote