View Single Post
  #5  
Old 04-22-2018, 01:37 PM
motopsycho87 motopsycho87 is offline
Senior Member
 
Join Date: Jun 2013
Location: Suffolk, UK
Posts: 905
Default

So, after a fair bit of jetting I've come to the conclusions of,

(My race bike)
2006 ec300, necj clip 1, 42/162
https://youtu.be/4fCE8rKm_2Q
https://youtu.be/SWtPVZNTCcI
https://youtu.be/_gJx3EHEric


(My sensible commuting bike)
2002 ec300 nedj clip 2 42/165
https://youtu.be/mglniKaEdV4


This is the cleanest my bike has ever run. I started with an NECH needle and 178 main that I'd used with the N3CH needle. The bike ran best with needle in top clip, so I out the NECJ in at number 2, it still ran rich up too, so I went down slowly, 175, 172, 168, 165, 162. I had to stop at that point as I was entering a land no gasgas rider had been to . So I put the 165 back in and dropped the needle, it ran cleaner on mid throttle, but still spluttered at the top, so then I tried 162 and top clip. DAYUM! She revs perfectly clean and has power to boot. Happiest I've been with the bike so far!
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear

2016 RM-Z450

Last edited by motopsycho87; 04-22-2018 at 04:12 PM.
Reply With Quote