Quote:
Originally Posted by RudolfHucker
The 2018 and 2019 wiring diagrams are identical.
The map switch connects to pin #4 on the CDI unit and the switch simply connects the pin to ground for the "wet" curve. If the switch is not connected, the CDI is set to "sun" curve.
I usually run my bikes on the "wet" curve by removing the switch and connecting a wire across the connector under the tank to short pin #4. Personal preference.
On the 2019, the connector is is a simple 2 pin type under the tank near the HT coil. you should be able to trace it from the CDI connector.
|
Many thanks, so you're saying there should be a connector under the tank on the 2018? Well, if not we can ground the #4 pin on the CDI to activate the softer curve.
On the 2019 it was as you said, I just had to plug in the switch which came with the bike.