I don't like the angle the bike leans over at with the stand down. Too far considering the tiny foot at the end. Setting it on different shims indicated that adding .750" would be about right. I put a 3/4" piece of PVC sheet under the stand and scribed the shape. Set the jigsaw to a 30* angle and cut the plastic. This flares the new foot out for more area. I left the straight side at 90* because it's close to the chain when up.
I drilled and tapped two M4 holes in the end of the stand, then bolted on the plastic piece and painted it silver. It looks odd but works well.
