has anyone ever experienced a worn down bendix fitment on the stator side? (opposite of the bendix cover, that is)
I'm a bit worried about this, there is no bearing and I think I feel some lateral play in the bendix. If a bedinx cover solves the play on one side, you still have the play on the other...
Also, the former owner did not install the washer (no. 15 ME25616070 Gas gas cent. washer 08.1x17x0,2) and the gasket of the stator housing is not installed.
Will this affect the alignment of the (no. 4) starter sprocket not too much?
ths sprocket has quite some damage by the way so I'm replacing this, and installing the washer
|