Quote:
Originally Posted by stainlesscycle
here's the symptoms:
i can kick bike in gear for dead engine start, have bike running, i click into gear, with clutch pulled, hit kill button. i keep clutch pulled and kick it and it starts fine.
but:
if i stall on the trail, in gear, pull clutch, and kick, clutch drags, and won't start. i need to shift to neutral to start it. this is a pain in the ass. i thought the plates would wear a bit and fix this, but it has not happened yet.
so, i'm assuming my clutch needs bled, and i've not been successful back bleeding it. i was thinking if i remove slave cylinder from bike, put a c-clamp on it, pump it once or twice so it's tight, then crack bleeder wouldn't the air be forced out of the line? can't figure out where air bubble is....
is there a foolproof way to bleed it?
|
Mine does the same thing. The basket is fine, no notches. Did it with new plates and worn out plates. Not sure there is a fix for it. I have heard of some trying different oils. Not sure if they had any success.
I have just chalked it up to a characteristic of my bike.