I am trying to get the Honda finished and ride it a little before the 2018 Gassers get here. I mounted a "Braking" Wave rotor on the front and an EBC vented rotor on the rear. I finished bleeding the front brake and it works good. I hooked up the rear brake master cylinder linkage with the 2014 YZ450F brake pedal. I was able to use the stock Honda pin but I had to bend the Honda clevis. I had bought a New YZF clevis but it was a smaller size than the Honda master cylinder and I could not use it. The YZF pedal bolt cleared the swingarm but it was a little close.
I was going to install a Megura 314 throttle but I had trouble finding a throttle cable that I thought would work. I got a good deal on a Domino Throttle and I bought a nos Honda throttle cover that slipped right on without a problem.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300
"If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut."
―Comedian Lewis Black
"I think best when I have a wrench in my hands." Soichiro Honda
"Dreams are messages from the deep."
-Unknown Sardaukar
Last edited by Moto7man; 07-19-2017 at 10:25 AM.
Reason: Grammer
|