View Single Post
  #136  
Old 02-07-2019, 12:04 PM
Moto7man Moto7man is offline
Member
 
Join Date: Aug 2011
Location: Murfreesboro,Tennessee
Posts: 2,537
Default New Parts

A lot of new parts are rolling into the garage.

18 and 21 Tubliss.


Goldentyre 216 Razor front tire with tubliss mounted on the new excel rim with Buchanan spokes. This was very easy to install.To the left is the unmounted rear Goldentyre Gummy GT523X, looks very wide doesn't it?



This is the rear gummy mounted up with the tubliss. This tire took a little more time to mount but it wasn't bad.I used armour all to coat the tubliss components and soapy water to seal the system. i bought two of these rear GT523x gummys, the other one is going on the gasser.



This is a VForce 3 Reed from a 1987 250/500 Quadracer, it is supposed to bolt straight into my RM cylinder. V3110-87. Also, this other part is a moose torque reed spacer. This should increase the bottom end and the cylinder has already been ported by Josh at ProCircuit and Josh milled the head to run on pump gas.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300

"If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut."
―Comedian Lewis Black

"I think best when I have a wrench in my hands." Soichiro Honda

"Dreams are messages from the deep."
-Unknown Sardaukar

Last edited by Moto7man; 02-08-2019 at 11:49 PM.
Reply With Quote