View Single Post
  #1  
Old 02-11-2020, 06:48 PM
Adam500 Adam500 is offline
Member
 
Join Date: Oct 2015
Posts: 56
Default ignition timing on a 2000 XC300

I took my stator apart to inspect and clean for a no spark problem.
I did not mark the position of the backing plate because I assumed there were marks on the case to line it back up. Ya know like every other motor on the face of the planet........
I later found out there is a oblong shaped washer that fits inside one of the backing plate holes that sets the position.
My bike never had that washer. there is a marked line on the backing plate that lines up with nothing on the case.
Anyone have a picture of the correct position of the plate or suggestions where I should start?
Reply With Quote