fse 400 valve timing ???????
Hello everyone - new on here and this is my 1st post hopefully I can get a bit of help
Just replaced the cylinder head on my GG and couldnt mark anything up before stripping as the chain had jumped the pulley and bent valves etc etc anyway according to a thread I was looking at on thumper talk there should be a timing mark on the flywheel to indicate the correct TDC - well I aint got one of them , I cant even tell where the ignition pick up gets its signal from
Any assistance here would be greatly appreciated (esp with photos) I have the 15 pins between the marks etc thats all ok I am just not sure if I have set up on exhaust TDC or ignition TDC
Thanks in advence Dave
|