I did exactly that on my 13 200 at 70hrs no problem.wossnerA for vertexA.the small end bearing supplied was wrong width so check it against the old.the correct one is a yz250 part crossover.
The gasket for the coolant 't' on the head
is not included in the set,and the washer on the small coolant drain bolt may disintegrate when you loosen it.
Dont pull the pv linkage rod up too much at any stage,*on reassembly of pv rod to pv actuator (rh top) its easy to accidentally do this as you tighten nut clockwise.
Enjoy!
__________________
2013 ec200r
|