Alright so I?ve got my starter working somewhat but I?ve encounter a few problems. I took all the electrical stuff off my dad?s ktm 300, including the reg/rec wiring harness relay and battery. I have it just sitting on the bike for now with the stator wire going to where the stator wire off the ktm went. Then I just ran the wire to my gas gas starter and with the press of the button it cranks as expected. My problem now is that the bike won?t start. There is a little ground on the coil that I took off because it?s part of the ac circuit and it was where I grounded the ground wire from my ktm wire harness. If I have both grounded at the same time it will start but there is lots of sparks and definitely is not correct.
Not really sure if this makes sense haha but I don’t really know how to explain it
Last edited by Jer; 10-01-2023 at 09:14 PM.
|