One Problem
I need help on one problem. I can't get the primary gear nut on the crank loose. I read some threads that said Suzuki put a high strength locker on this nut and it was only removable with heat. Some thought the bolt was a left hand thread because it was so hard to remove, but other said it was right hand thread but it took a lot of heat. I put PB blaster and the torch on the nut, then put my 1200 pound Milwaukee Impact Wrench on it, it didn't move the nut at all and it rounded the edge of the nut but I stopped immediately and I straightened the damage with a file.
I could use my 3/4 breaker bar with a 3/4 inch 19mm socket.
Any suggestions?
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300
"If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut."
―Comedian Lewis Black
"I think best when I have a wrench in my hands." Soichiro Honda
"Dreams are messages from the deep."
-Unknown Sardaukar
|