Update
On disassembly of the carb, this is what I found:
Main Jet: 175
Pilot Jet: 42
Idle Screw: 4 turns out
Pilot air screw: 2 turns out
Float Height: ~6.3mm reset to ~7.5mm
Needle visually perfect with the exception of a small gummy/rubbery lump just below slide.
Slide has some visual wear on lower section of intake side.
I didn't remove the needle to try and identify. I believe PO said it was a Yamaha needle. I have new JD needles. Should I install the Red one?
Vent hoses were all kinda crusty and stiff, so I am replacing.
I also ordered new Gasgas CDI and Coil. It should be here by tomorrow.
Am I missing anything else? I just want to get this bike running like I know it should! Thanks for your help.
|