Ok so my Base Valve will look like this?
*
Nut
Cup Washer 4 holes
Spring
big silver washer with collar
Piston
32mm (x6) 0.11mm
26mm or 28mm (x1) 0.11mm (I will see if I can find one in a set of WP43s)
32mm (x6) 0.11mm* (stock was 18x 32mm)
30mm (x1) 0.11mm
28mm (x1) 0.11mm
26mm (x1) 0.11mm
24mm (x1) 0.11mm
22mm (x1) 0.11mm
20mm (x1) 0.11mm
18mm (x1) 0.11mm
16mm (x1) 0.11mm
14mm or 13mm (x1) 0.3mm
20mm (x2) 1.58mm
11mm (x2) 0.25mm
I see your point how adding the 13/14mm will soften the whole stack.
So if I understand correctly, my present stack does not have a bleed shim because the 32mm shims are placed directly against the piston? A bleed shim in this stack might be an 11mm placed between the piston and the first 32mm of the main stack?
This may be a silly question but if I can not get a single 13 or 14mm x 0.3mm thick can I build it from multiple thinner shims (adding up to 0.3mm) and get the same results?
|