I found an RM replacement shock and sent it to Drew at Works Enduro Rider. Drew is also going to install a set of Racetech Emulators in the forks. I had a big batch of OEM suzuki parts arrive and started getting them installed.
I pressed new bearings and seals into the upper full floater arm. Everything went together very nice and it was fairly easy to fit to the frame. Just make sure that you don't lose any needle bearings when install the long spacer and long pivot bolt.
This is what it looks like installed.That cad plated gold rod in the middle is actually a spacer and the pivot bolt goes through the center.
This is a shot from the side which show the pivot bolt and the new linkage arms bolted up with all new Oem Suzuki fasteners including new shock bolts.
View from the back, notice the new suzuki chain guard and bolt to the left.
New oem engine mount bolts and spacers.
New oem rear fender.
New oem front plate.
New oem fork boots