View Single Post
  #9  
Old 04-08-2017, 08:13 PM
Jakobi's Avatar
Jakobi Jakobi is offline
Super Moderator
 
Join Date: Oct 2010
Location: Australia
Posts: 7,994
Default

You can try the 14x.11mm clamp. Usually just aim for more to allow more room for the shims above to flex over the clamp if required.

You can try the 24mm crossover if you like as well, or simply leave the crossover right out and run a straight stack.

With the KYB they have an option for a bleed stack. This essentially bypasses the clicker. By running your 11.25 (2) and the spacer at the bottom of your compression stack you are leaving the small ports open, and bypassing this.

This is different to what is referred to as a bleed shim, and that is exactly what you have said above. It sits between the face shim and piston face to allow the ports to be partially open at all times, allowing bleed.

The free pistons, if they aren't broken and look in good condition I would simply drill them to avoid the pressure build up that breaks them. Otherwise if you want to drop some coin you can get the metal ones.
Reply With Quote