[adriangtzxr]

My compression clicker is leaking like a sieve. I am assuming that it is a bad internal o-ring and maybe some dirt.

I have the lower compression (nut) unit out but that is as far as I can go. Replacing the larger external o-ring while I'm at it. I can not figure out how to disassemble the unit to extract the screw. No snap rings that I can see? I have attached a few photos. Any tips are appreciated!

-Adrian

Note: The bike is a 2009 GG six days (allegedly) Forks didn't have markings so making the assumption it is a shiver 45mm due to diameter and physical appearance. The Marzocchi shiver manual was no help.