You must have the estart model. It uses a DC powered CDI, so the "single winding" wires are not connected to anything. You should get a high AC voltage on the two wires going to the rectifier. If not the stator may be bad. Clean and grease every wiring connection. Clean every ground point then try running the bike and checking AC voltage out of the stator. If it's high (50-60 volts), then check the DC voltage out of the Reg/Rect. If low you need a new Reg/Rect. If your battery voltage drops low enough the CDI may start misfiring.
Download the 2014 GG enduro manual. It has wiring diagrams in it.
__________________
2011 EC250E
|