Is the flange tight on the cylinder? The '06 should be a steel flange.
Do you have the GG pipe?
I noticed that my '07 seems to leak a very small amount of spooge from the spigot/pipe a lot quicker after an o-ring swap than my '00 and '03 did. I think the pipe flange is just not as snug a compression fit on the o-rings as the FMF. All I did was clean everything up perfect with contact cleaner, and use hi temp RTV on the o-rings instead of grease. Seemed to solve the problem so far.
I imagine if the pipe is even slightly tweaked at teh spigot this situation will be aggrevated.
|