View Single Post
  #5  
Old 10-11-2018, 04:44 PM
Davehuge's Avatar
Davehuge Davehuge is offline
Senior Member
 
Join Date: May 2017
Location: English but now based in South of France.
Posts: 470
Default

What I would do...

Remove the kickstarter lever and the shaft should rotate clockwise until it hits its stop. Then replace the lever in the position where you want it.

As Jakobi says... if the shaft isn't been turned hard against its stop by the return spring, then something is out of place and you need to remove the right side gearbox cover. It should be quite obvious to see.

Good luck, Dave.
Reply With Quote