Quote:
Originally Posted by jimbolaya
Hey Eff,
the clip is in the middle position as requested by instructions. I didn't think dropping the needle would clean up the off idle richness that's one reason it isn't already done. thanks for the tip. I'll try that first.
I heard from my local gasgas dealer not to run below a 45 pilot, but if I can't get the airscrew below 2 1/2 turns out I've lost the adjustability of the airscrew to lean out that circuit. I will report back how that adjustment goes.
thanks!
|
The instructions are based on 60ºF I believe. Refer the the std jetting chart in the manual to change from there.
I was running the 48 pilot, air screw 3 turns and the clip in the middle. I took my bike for a spin after I put on the LTR 126MM links (a couple of weeks ago). It sputtered, and was clearly running rich. I popped open the carb and raised the clip one and turned the air screw to 2.5 turns and things ran smooth.
