Quote:
Originally Posted by gasgasman
Just by looking at the pictures.
You will need to replace the pivot bolt with one that is flush. This will allow the pivot tab to slide past the pivot bolt and change the spring fulcrum point.
|
that's about 1/2 of the solution. That pivot bolt is actually an intricate little bushing that goes through the stand and over a post in the frame. So yes, I think ill need a button head bolt, but more importantly I think I'll have to either 1) manufacture a new bushing that doesn't have the edge on it, or 2) cut the edge off the one that's on there.
I may take the bushing out and go to the hardware store and see if I can match up the inner and outer diameters.