[MattR]

Originally Posted by Krasi

...which clicker does what?

Here are pictures of my suspension (09 EC300):

Pic 1 - Front Top
This adjusts the rebound damping.



Pic 2 - Front Bottom
This adjusts the compression damping.



Pic 1 - Rear Top
There are 2 adjusters. The inner screw adjusts the low speed compression. The outer knob adjusts the high speed compression.



Pic 2 - Rear Bottom
This adjusts the rebound damping.

I added the clicker references under each title above.

Just remember...
Write down your current settings for a baseline. Count the number of clicks until the screws/adjusters are fully seated (inward). This will establish the "number of clicks" to return to your baseline setting. Most people refer to the settings as "number of clicks out from fully seated". Where fully seated would provide the maximum damping setting (slowest rate of rebound/compression motion).