Quote:
Originally Posted by bergerhag
The software has a metering mode, where you can see all sensor readouts, as well as throttle opening angle(as measured by the TPS sensor), rpm, and temps. Verify those temp readouts to actual surronding environment. Water temp sensor is located on the left rear of the cylinder head, close to the intake.
|
Berg,
Where is this metering mode your talking about, where I can see all the sensor readouts? I can go to the Gauge menu and see the throttle opening angle degrees and rpms, etc. but not the sensors? Where exactly is the air temperature sensor? When I take my gas tank off, I can see where the gas line goes in and some other sensor to the intake. Is that the water or air sensor?
Thanks again,
Crankin04