Hi All
So I've just rebuilt my 2011 EC250. Apart a stubborn gasket supplier who insisted gaskets for 2002 - 2011 are all the same, it all went pretty well.
Until I tried to start it. It's had nearly everything new, crank bearings, seals, conrod, piston, re-coated cylinder etc.
This is what it sounds like when I try to start, just nothing there at all.
https://youtu.be/D5_LoQ485ZM
I also re-did quite a bit of the dogdy wiring, so I was concerned about that, but the spark looks ok:
https://youtu.be/CnPv9xeM_gQ
I haven't touched the carb, it seems to be getting fuel as the plug was wet.
It's been a long day so it's probably something simple, but I can't help thinking it's something deeper that I fecked up..... Spark + Fuel + Compression = Bang Bang right?
Any ideas welcome, thanks in advance.