Quote:
Originally Posted by pscook
Is there a shoulder on the sprocket shaft? If so, that is the spacer. Pull that out and there should be two o-rings, one in the recess of the spacer and another just past that. Be careful pulling the spacer off with pliers as you don't want to mar the outer surface.
*Speaking from experience with XC300 and other dirt bikes.
|
nope. no shoulder it goes from splines to smooth shaft into the engine bearing. with the seal fully seated in the housing and the sprocket on, the inside edge of the sprocket is touching the seal.
I'm hoping someone with a 2005 has done their seal?