Thank you both.
Jakobi -So to make sure I understand you correctly I should modify it like this?
Midvalve
*
Nut
Washer
11mm*(x1) 0.25mm
12mm (x1) 0.11mm
14mm (x1) 0.11mm
16mm (x1) 0.11mm
18mm (x1) 0.11mm
13mm (x1) 0.11mm
20mm x0.045 (x4)* 0.11mm (Stock had 4)
Piston
20mm x 0.045" (x3)*0.11mm (Stock had 4)
17mm x 0.045" (x2) 0.11mm (Stock had 3)
11mm x 0.01" (x2) 0.25mm
17mm x 0.01" (x3) 0.3mm
17mm x 0.045" (x2) 0.11mm (moved from above)
Collar
*
*
Base Valve
*
Nut
Cup Washer 4 holes
Spring
big silver washer with collar
Piston
32mm (x6) 0.11mm
26mm or 28mm (x1) 0.11mm (I will see if I can find one in a set of WP43s)
32mm (x6) 0.11mm* (stock was 18x 32mm)
30mm (x1) 0.11mm
28mm (x1) 0.11mm
26mm (x1) 0.11mm
24mm (x1) 0.11mm
22mm (x1) 0.11mm
20mm (x1) 0.11mm
18mm (x1) 0.11mm
16mm (x1) 0.11mm
14mm or 13mm (x1) 0.3mm [U](I will see if I can find one in a set of WP43s)
Do I remove both 20mm and the 11mm or do I keep the 11mm?
Thank you for the help!
|