View Single Post
  #35  
Old 08-29-2014, 03:07 AM
@enrico@ @enrico@ is offline
Member
 
Join Date: Aug 2014
Location: Italy
Posts: 23
Default

I know all you sad but I do not share when you say rich first taper ecc....

N8rx has a richer first taper than N1Ex.

Then the taper are the same until N1Ex has its third taper much richer than last second taper of N8Rx.

The first taper on triple taper needles "eat" part of straight section so they're richer just out of straight than the same diameter two taper needle that is still in straight at the same throttle opening.

So I ask if you know the profile shape of you suggested needle because if the tapers are the same and starts in the same point ( or half clip different ) they're useless.

The rule is: the thicker the diameter and the shorter the straight section.
Reply With Quote