Quote:
Originally Posted by GMP
They do look nice but forget about bling for a minute. What do you see that makes these potentially inferior to the flatland guard? No tie back to the head stay, no side coverage, and judging by the hole placement they sit much closer to the radiators, which hurts airflow and provides less room for front impact damage.
For less than $100 you get a set of Flatlands, add TWO sets of GP braces for $60, adding an upper shroud mount.
For less $$ this is the most bulletproof radiator protection setup you can get. I crashed hard enough last week to flex the right shroud to the point of breaking the brake fluid resevoir. The side of the Flatland guard was bent toward the rad only about 3mm in the center between the GP braces, they did their job. The shroud was fine, the rubber isolator I use for the upper mount separated and was eaisly and cheaply replaced.
|
Here is a good thread to address your side impact concerns.
http://ktmtalk.com/index.php?showtopic=192810