[Eric K]

I was getting tired of cleaning the screen on my Sparky spark arrestor which is on the end of a stock GG Euro silencer. I read that a ’99-02 KX FMF Q silencer would fit the GasGas, so I bought one off ebay.

The Q silencer is about as long as the stock GasGas Euro silencer (w/o the Sparky) and a few inches longer than the GasGas FMF TC2 silencer.

Fitting the silencer on my ’06 EC300 required the following…

> Trim ~0.2 inches off the end of the stock GasGas pipe.

> Trim ~0.4 inches off the silencer tube where it slides over the pipe.

> Slight trim of the rubber sleeve that fits over the pipe joint.

> Bend the silencer body up a few degrees relative to the silencer pipe to get the mounts to align.

> Bolt into place.

The FMF Q tucks in well and provides adequate tire clearance. It fits pretty well except that the highest point on the silencer just touches the rear fender.

I can’t hear a difference in noise level between the FMF Q and the stock GG Euro silencer with the rest of the engine noise.

As a note, the KX FMF Q would not fit on my ’01 XC300 as it had too much interference with the rear fender.