Is it possible to wear a divot in the bottom of the slide where it contacts the screw? I imagine the plastic tip Ron mentions is to prevent that?
The idle screw on my '05 MC 250 is just about all the way in to get a proper idle. The tension spring appears to be fully compressed. I didn't notice that there was a plastic tip on the screw, but I wasn't looking for one when I cleaned the carb.
Could it also be incorrect idle jetting? Ron would be the guy who knows.
__________________
Ross
'05 MC 250
'91 Husky 610wxe
'04 Duc M800 R.I.P
'06 Duc S2r 1000 R.I.P
'07 Duc S2r 1000 still rubber side down...
----------------------------------------------------------
May be so... May be not so...
My Website
|