Did I read somewhere that the Vertex piston is stock?
Then Go Fasters should have rings, wrist pin etc. no? Some other supplier for Vertex stuff?
I'm also intrigued by some of the talk I saw about port timing a while back.
http://www.gasgasrider.org/forum/sho...3296#post23296
As long as it's apart I figured I might as well check and see if it's at least close. Lots of theorizing but I didn't find any concise info on how one goes about checking it or what it "should" be. I measured the single green gasket that was on there and it's about .30mm
__________________
Ross
'05 MC 250
'91 Husky 610wxe
'04 Duc M800 R.I.P
'06 Duc S2r 1000 R.I.P
'07 Duc S2r 1000 still rubber side down...
----------------------------------------------------------
May be so... May be not so...
My Website