[exman]

Mr Jakobi you were right about the Part number. I have attached the picture but there isn't much to see, I have found only traces of some grey sealant on both sides of reed cage and no gaskets. It seems I'm gonna make two gaskets as a first aid and try to find genuine. By the way, is any visible gap allowed between reeds and reed cage?..I'm asking because of the problems that I have with idle probably caused by air leak (mentioned in my post in Technical forum). I am "new kid on the block" here but it has already became clear to me that jetting is the key word in 2T (and may be power valve has some influence). So I'm trying to establish basic settings as a good start and appreciate the support from all of you guys.
Spring is in sight and I hope my Gasser will be as ready as I am for the riding season. When you are 65, there's no time to waste.