Writing on rings up, check. Pins aft (intake), check. Arrow fwd (exhaust), check. Ring gap at 0.5mm 1" below cylinder deck, check. Piston edge at BDC is about 0.8mm (roughly) above exhaust port floor. Final gasket stack is ~1.4mm.
I read the link regarding gaskets the other, Jakobi, hence my questions (made me more confused, per the usual). Looking through it now, I do not see a reference to exhaust port/piston, just gasket stack. I just had the cylinder lined so I don't particularly want to start running a dremel around the ports, plus I wouldn't know where to start. I can drop the cylinder a bit, but I don't know if it's worth it.
Keg- What do you think regarding 1.4mm gasket stack? 2002 EC300, I don't know if the porting is stock or not. It was allegedly built by Eric Gorr many moons ago but there was no build sheet with the bike. I don't know the squish, I'll measure tomorrow.
|