View Single Post
Old 09-18-2021, 03:17 AM
Gasser Nate's Avatar
Gasser Nate Gasser Nate is offline
Senior Member
Join Date: May 2010
Posts: 621

The 4 strokes were an absolute pain in the ass but the kokusan models were miles ahead of the early magneti marelli equipped ones.
The did have a setting but I have lost all my factory specs on them. The air bleed screws worked best around 1.5-2 turns out. If the throttle stop screw has not been played with DONT!
The idle is usually set quite high around 1800rpm.
When I was at the dealer we had the performance Gasgas map and the software to update it. Cost us a bomb from Gasgas and only worked on one dinosaur computer.
Did make them run a lot stronger and start easier. Also had the diagnostic capabilities as well.
Back on a gassy! 2018 EC300! 🤘
Txt 280 07 to make me feel like a gumby again
Reply With Quote