Thanks for the help everyone. After getting my tools out and doing it I realize how stupid my questions were. Two more stupid questions... on the spacer there is a foam ring that is glued to it...is this just to help keep the spacer centered when removing and installing bearings?
Also I took the 2 bearings out on the sprocket side first and the spacer came out. When I flipped it over to do the rotor side I put the punch on the inside of the surface that the bearing mounts to instead of the bearing. It took a a small chip out of this surface. It is not on a surface that the bearing will touch. I do not think any parts wil touch it but I just want to make sure that nothing will be messed up. I am going to take a file and smooth it out. Before putting the new bearings in. Will it effect anything?
|