Quote:
Originally Posted by Jakobi
Go back through this thread Phil. There is all the info required on how to set the Lectron up. Even pics of where my fuel height was.
Note that these carbs will be hard to start if the slide is too high. They need to be nice and low to get a good signal. First page of the thread for pics. Good luck.
|
Thanks for the tip, but, and with no disrespect, I was looking for advice a little closer to home, and for the 300. I will start with your (exceptionally well documented) settings, but I was testing the water to see if there was a particular setting for NW Washington.
I think that my float is a bit too high, as the fuel goes right up to the bowl joint at the front. I'll drop it a mm or so, set the slide at a touch above closed, and go from there. I think my metering rod is already at 50.XXmm, so it's pretty close. I just need to confirm the power jet setting (which only affects WOT, right?). It was getting fuel, just not at the right mix.