View Single Post
  #19  
Old 07-22-2009, 12:36 PM
brains's Avatar
brains brains is offline
Senior Member
 
Join Date: Jan 2007
Location: Hillcrest KZN SA
Posts: 124
Default

For most parts you don't have to but from the factory.

The bottom end being a Derbi Senda 50cc, you can just get Derbi parts.

I can't remember what I worked out about the hydrolic clutch, I think it was a Derbi part as well.

The AP brakes are used on other bikes like Polli.

As mentioned, the top end is Metra kit.

The reeds are Derbi

The pre 08's were Delerto and then the factory came to there senses and fitted a Mukini. I have tried the Mukini 24mm, same as the KX 65, it was much better.

The expansion chamber is very much like the KTM 65

The rear plastic comes from the same mould as the KTM and even has a KTM stamp on it, just different colour.

Painterman - the electrical problem was the coils going faulty. We had them rewound and had no more problems after that.

What did Oerlemans find out and do with the MC 65?

I still have a MC 65 sitting in pieces and not sure what I may do with it, maybe Oerlemans will give me some inspiration. My main problem with it was that the bike has no bottom end power as from factory. After big mods we sorted some of the problem out, but it is still no where near the power of the KTM SX 65.
Reply With Quote