Quote:
Originally Posted by Demi
Hopefully I can make it look good, being that the hole is on the back side, it should be ok. Thanks for the support!
|
Here, p. 4 and 5 in the thread,
https://thumpertalk.com/forums/topic...ge/4/#comments
Quote:
If you want to check to see if that screw did back off you'd have to drill a hole behind the case. There should be a decent gap of a couple mm between screw and case.
It's easy enough to seal up the hole with jb weld when the case is off the bike. Use painters tape around the hole in the shape you want and you can peel while jb is still wet for a clean look. It's also very difficult to see the jb weld when the case is back on.
The grey on black is the jb weld on my case while on the bike.