tranny
my 99 300 had an issue! it would either stay in one gear or not go in,,,it had VERY low miles and before i split the cases and checked shift forks and such i noticed a lot of play in the shift shaft! pull and push it to see if you have the same scenario! what i did was cut a small piece of p.v.c. tubing and installed it between the shifter itself and case (kinda float it in there)! cut it a lil smaller so it doesntpush against the seal or the shifter! after i did it i rode the bike for the rest of its life like that and never had another problem! not sure if thats your issue but it may help you! good luck and git 'er goin!
|