View Single Post
  #1  
Old 06-11-2014, 10:37 AM
jprizz jprizz is offline
Member
 
Join Date: May 2014
Location: Temperance, MI
Posts: 59
Default Ec300 clutch assembly position

I needed to replace my kick start shaft so I disassembled my clutch to do so. Then I read this in the shop manual:
Note:
The clutch hub has an assembly position with respect to the primary shaft. Mark the position using a permanent marker on the grease ring.


So how important is this? Since I didn't mark it is there any way to determine the assembly position? Is it because its balanced or something?

Thanks,
-Josh
Reply With Quote