[Bandit9]

The bracket/mount came with my bike. So did a Cycra CRF plate with a brake line bracket thingy on the front of the plate. This plate is trashed so I'm buying a new one. What I would like to do is utilize the two fender pins like scov did and trim off the lower part that you would normally zip tie around the fork. I can't tell if the Cycra had the material at the bottom where I could drill the two holes to line up with the fender pins. It doesn't now, but it looks like it had been trimmed up a good bit.

So does the Cycra have something to drill into at the base where it meets the fender pins? Or do I need to get the 09 CRF plate to do it that way?

Thanks

Blanco