View Single Post
  #6  
Old 08-16-2012, 12:56 AM
bergerhag's Avatar
bergerhag bergerhag is offline
Gold Level Site Supporter
 
Join Date: Nov 2006
Location: Timr?, Sweden
Posts: 675
Default

There should not be any voltage on pin 19, using an ohm-meter to measure on live electronics is sure to get irratic results. Can you get the fuel pump relay to pull if you ground the cable to pin 19? (migth wanna disconnect it from the ecu first.

I have attached a different schematic, an older version. Might do you some good.
Attached Files
File Type: pdf 46. Scheme A3 Electronic Ignition IAW 15P.pdf (73.8 KB, 321 views)
Reply With Quote