View Single Post
  #1  
Old 03-01-2011, 09:03 PM
rgranger's Avatar
rgranger rgranger is offline
Gold Level Site Supporter
 
Join Date: Dec 2007
Posts: 699
Default Clay, i have a WTF starter question on EC 300 2011

it was working fine for all day sunday. put it up and today started it to test the speedo and the starter would not disengage. if I pop the motor off the bendex is all bound up, the only thing to do is loosen all side cover bolts and then it will spin free. any snug on them at all and the damn thing binds right up on using the e-start. is there some ninja trick to getting the side bolts tight enough so that they don't fall out but wont bind the bendex either?

Frustrated as hell right now.
Reply With Quote