Yes, one thing at a time. You should not be too rich with a 175, in fact that was borderline lean in all of my 3 250s. I run a 180 and my bike is an animal on top, not rich. I also agree with gasser, the CCK is a bit lean and flat for a 250 especially with a 7 slide, better in a 300. These bikes go flat on the torque if lean, better to err on the rich side if any. Check your PV, reeds, float height, primary crank seal, ignition. I assume Ron cut the slide so its correct? Did he replace the nozzle? Get a DDK, DEK to experiment with.
Oh, yes the clutch should work fine.
|