[hadfield4wd]

Time for some updates. I split the case and sent the crank to MrCrankshaft.com for a rebuild. I also replaced the crank bearings. Leaving the case in the garage and the bearings an crank in the freezer. Makes it all go together pretty easy. I also replaced the swingarm bearings. I have a new (to me) front tire on. The forks are cleaned out and fluid changed. The seals seem to be in good shape so at this point I’ll leave them. If they start to leak I’ll replace them. New grips, handguards, handlebar, rear fender. Also I have 8ox of flywheel weights installed. Any bearing that hasn’t been replaced has been cleaned and greased. I’m waiting on a spoke for the rear wheel. One is missing and so is the nipple so I can only imagine that it was left off by somebody on purpose. I also need the cylinder back and then order a new piston.