Thread: Running issues
View Single Post
  #17  
Old 01-13-2020, 08:44 AM
eralha eralha is offline
Senior Member
 
Join Date: Sep 2018
Posts: 103
Default

Quote:
Originally Posted by TGM_OFFROAD View Post
Hey everyone, I am trying to sort out my 18 XC 300. Long story short I had some issues with my left and right crank seals for which I ended up blowing my top end. I replaced the piston and rings, had the cylinder inspected and was told it was still in good shape. I have some running issues with it which I suspect may just be carb related, dialing in my lectron still. I can see some light through the reed pedals so I am replacing those. I have an excessive amount of carbon build up on my piston for the low hours but all other points suggest my bike is running lean. I also tested the compression but did so without the reed block in (not sure if that will lead to inaccuracy or not) and am only seeing 115psi. See video below for how the bike sounds. I have gotten some suggestions to try but looking for all the help I can get. I love the way this bike handled and the suspension is amazing after I got it valved for me. I just want the engine to run right and have the power I need

https://youtu.be/fDLVyj2sGh8
Hi i have an EC 300 2018, my bike is running like your's, i tryed cleaning up the carb e checked the reed's, with no success on solving the problem.

Did you problem got away after the crank seals replacement?

How did your problem starter? Mine started all of a sudden.

Do you have to split the cases to replace the seals?

i'm realy getting desperate with this.

Thanks mate.
Reply With Quote