Quote:
Originally Posted by nknudsen
Depending on how's it bent up, I would strip it down completely so it's just the bare subframe bolted to the frame. Take measurements to different areas of the bike to reference from side to side & up and down. Use a long chunk of 2x4, square tube, pipe or whatever and carefully work it back it it's original position still mounted to the main frame. Get creative, maybe use a small bottle jack too if needed.
|
It was severely bent when I took it off the bike last night. Not when worth saving unless you want to spend some time on it. It is lighter than the steel one I just got, but I can't see the steel one bending at all. Much better quality.